Our website uses Cookies to personalise content, provide social media features and to analyse our traffic whilst delivering the best possible experience to our users. If you'd like to find out more, please read our Cookies Policy.

VGS Vehicle Glazing - Tinted Privacy Glass Toughened Windscreen ;

Hole Cutting Guide

Step 1

Mark out the side of van with provided measurements

Defender 90: 205mm from front door edge 160mm from rear edge 50mm from top of panel 50mm from bottom of panel Defender 110: 120mm from door edge 140mm from rear edge 50mm from top of panel 45mm from bottom of panel use roll of masking tape for corner radius Tip: Use new masking tape roll on the corners.

Step 2

Remove the inside brace

With a screw driver and hammer, bend up the lower tabs on each side of the brace and break this away from the rivets; the bottom should now be loose, slice down the back of each side with a Stanley Knife. Once this is completed, gently wiggle the bracket until it comes away from the rivets at the top. When the bracket is free, you will need to grind the rivets flat.

Step 3

Cut out the side panel

If you are using a Jigsaw to complete this task, we strongly advise you tape around the edges of the hole you are cutting.

Step 4

Fit your new panoramics

You will require your Metal Edge Trim provided in your kit, with this handy please proceed to our Panoramic Fitting Guide. Tip: Feel free to call us for more advice or use our professional fitting service.